Advertisement
Chassis - Chassis, Hood and Fenders
Section 100-0010
2. Block all road wheels and place battery master
switch in the 'Off' position.
3. Attach a suitable lifting device to the component and
remove mounting hardware. Remove the component
from the vehicle.
INSTALLATION
Note: Tighten all fasteners to standard torques listed
in Section 300-0080, STANDARD BOLT AND NUT
TORQUE SPECIFICATIONS.
WARNING
To prevent personal injury and property
damage, be sure wheel chocks, blocking
materials and lifting equipment are properly
secured and of adequate capacity to do the job
safely.
Using a suitable lifting device, align the component to
be installed in position on the chassis. Secure the
component securely to the chassis with mounting
hardware removed during removal.
REPLACEMENT OF SPINDLE
Damaged spindles (2, Fig. 1), oil transfer tubes and
banjo outer plates can be removed and new ones
installed by following the procedures described in this
section.
WARNING
To prevent personal injury and property
damage, be sure wheel chocks, blocking
materials and lifting equipment are properly
secured and of adequate capacity to do the job
safely.
1. Position the vehicle in a level work area, apply the
parking brake and switch off the engine. Operate the
steering in both directions several times to relieve any
pressure in the steering system.
2. Block all road wheels and place battery master
switch in the 'Off' position.
2
12 13
11
1 - Hood Assembly
2 - Cover Assembly
3 - Support Assembly
4 - Nut
5 - Lockwasher
6 - Washer
7 - Bolt
8 - Bolt
9 - Washer
10 - Nut
Fig. 2 - Exploded View of Hood and Mounting
3. Remove all components from the spindle to be
replaced. Attach a suitable lifting device to the
component and remove mounting hardware. Remove
the component from the vehicle. Refer to
Section 160-0050, WHEEL RIM AND TYRE, for tyre
and wheel removal; Section 160-0040, PLANETARY
GEARING, for axle and planetary removal; and
Section 165-0031, BRAKE PARTS, for brake removal.
4. Remove sun pinion and axle shaft from the opposite
side of the machine. Refer to Section 160-0040,
PLANETARY GEARING, for procedure.
5. Remove differential from the banjo. Refer to
Section 160-0020, DIFFERENTIAL.
Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688
1
7
5
6
8
9
5
10
16
4
RH FRAME RAIL
LH FRAME RAIL
11 - Bolt
12 - Washer
13 - Lockwasher
14 - Bracket
15 - Stud
16 - Recepticle
17 - Retainer
18 - Bolt
19 - Washer
20 - Lockwasher
SM - 2367
2
17
15
14
3
18
20
19
SM 1690 Rev 1 11-99
Advertisement
