WARNING Never use parts which are altered, modified, or weakened in operation. This can seriously jeopardize the integrity of the machine and could result in property damage or serious personal injury. SM 222 Rev 1 9-93 Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688...
Page 6
THIS PAGE IS INTENTIONALLY LEFT BLANK Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688...
Page 7
TABLE OF CONTENTS Section No. Description SM No. GENERAL INFORMATION 0000 TS14F Technical Data 1689 CHASSIS 0010 Chassis, Hood and Fenders - Tractor 1690 Rev 1 0130 Steering Trunnion - Tractor 1695 ENGINE 0030 Engine and Mounting 1691 Rev 1...
Page 8
Cutting Edges and Side Blades 1726 MISCELLANEOUS 0020 Lubrication System 1720 Rev 1 0070 Service Tools 1802 Rev 1 0080 Standard Bolt and Nut Torque Specs 1238 0090 Unit Storage 1239 SM 1687 Rev 1 11-99 Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688...
Page 9
GENERAL INFORMATION - TS14F Technical Data Section 000-0000 SM - 2090 3 440 (11-3.5) Max. Width 3 060 3 060 (10-0.5) (10-0.5) 2 260 2 260 (7-5) (7-5) 1 460 1 460 (4-9.5) (4-9.5) 3 150 (10-4) to ground 3 810...
Page 10
General Information - TS14F Technical Data Section 000-0000 BRAKES Maximum Torque Full air operated drum brakes with automatic at 1 600 rev/min ......644 Nm (475 lbf ft) application on loss of air pressure. Secondary system Number of cylinders/configuration ....6, Inline can also be manually applied.
Page 11
General Information - TS14F Technical Data Section 000-0000 ELECTRICAL SYSTEM Servo Control Functions: Capacity at 2 200 rev/min ......43 litre/min Type ........24 volt, Negative Ground. (11.3 US gal/min) Battery ........ Two, 12 Volt, 165 Ah each System Pressure Accessories ............
Page 12
THIS PAGE IS INTENTIONALLY LEFT BLANK Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688...
Page 13
Operate the The engine supports, transmission supports and steering in both directions several times to relieve any various other brackets are welded in position on the pressure in the steering system. frame. SM 1690 Rev 1 11-99 Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688...
Refer to Section 160-0040, PLANETARY GEARING, for procedure. 2. Block all road wheels and place battery master switch in the 'Off' position. 5. Remove differential from the banjo. Refer to Section 160-0020, DIFFERENTIAL. SM 1690 Rev 1 11-99 Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688...
Page 15
1 - Radiator Guard 3 - Grille 5 - Lockwasher 7 - Washer 2 - Seal 4 - Bolt 6 - Bolt 8 - Seal Fig. 4 - Radiator Guard and Mounting SM 1690 Rev 1 11-99 Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688...
Page 16
9. Install the oil transfer tube as described under the fabricated as shown in Fig. 6, through the spindles and heading ‘Oil Transfer Tube'. banjo. Align the spindle to the dimensions shown in Fig. 5 and tighten alignment tool. SM 1690 Rev 1 11-99 Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688...
The 'Gasfoe' respirator has been approved by the U.S. Bureau of Mines: Approval number 23B-10, and is designed to protect against gases, vapours, and/or metal fumes. SM 1690 Rev 1 11-99 Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688...
Page 20
Surfaces must be prepared using paint stripper prior to area being reworked. Recommended Industrial Hygiene and Safety Rules should be followed for protection of the welding operator from fumes. SM 1690 Rev 1 11-99 Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688...
Refer to Section 220-0010, STEERING LINES AND FITTINGS. 3. Block all road wheels and place battery master switch in the 'Off' position. SM 1695 2-99 Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688...
These tools are available from your dealer. Note: Tighten all fasteners, without special torques specified, to standard torques listed in Section 300-0080, STANDARD BOLT AND NUT TORQUE SPECIFICATIONS. SM 1695 2-99 Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688...
Page 24
THIS PAGE IS INTENTIONALLY LEFT BLANK Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688...
Page 25
The engine is mounted to the tractor frame at three type. Oil supplied by the engine oil pump passes points by a mounting bracket at the front of engine (1) through oil filter (2) before reaching the various moving SM 1691 Rev 1 11-99 Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688...
Page 26
The amount of fuel injected and the beginning of injection timing is determined by the ECM. The ECM sends a command pulse which activates the injector solenoid. SM 1691 Rev 1 11-99 Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688...
Page 27
The fault should be diagnosed and corrected at the earliest opportunity. 4. Batteries - Two 12 volt maintenance free batteries supply the machine with electrical power to operate all electrical components. SM 1691 Rev 1 11-99 Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688...
The operator must maintain control of the moving vehicle while the assistant performs the diagnosis. SM 1691 Rev 1 11-99 Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688...
Page 29
& road speed limiting, if enabled and limites engine speed in all gears. 23 wide-window TRS signals were not received between two None If condition persists, engine will stop running. narrow signals. SM 1691 Rev 1 11-99 Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688...
Page 30
ON engine OFF standard diagnostic test (ie. voltage drop across pins 17 & 37 was not between 5 - 20 Ohms). Main power relay failed the output circuit check, during key ON None None. engine OFF standard diagnostic test. SM 1691 Rev 1 11-99 Find manuals at http://best-manuals.com/search?&s=TEREX-SM1688...
Page 31
This as a preview PDF file from best-manuals.com Download full PDF manual at best-manuals.com...