Mäktig 710135 Owner's Manual page 14

6. 2A current indicator – Indicates the charging rate you choose is 2A.
8A current indicator – Indicates the charging rate you choose is
7.
8A.
8. 12A current indicator – Indicates the charging rate you choose is
12A.
9. Charging rates selecting switch – You can choose the charge
rates-2A, 8A or 12A ,by pressing this switch.
10. Display Button Switch – You can choose what to display on the
panel by pressing the button. The default display is the current
charging rate.
11. Reverse Polarity LED – Red LED. When clips connected the battery
in the wrong way, this red LED illuminates.
12. Battery Recondition Indicator – Yellow LED. When the battery is
reconditioned, this LED flash. The charger will estimate automatically
whether the battery recondition is needed. It will recondition the
battery only when the battery has gone into float charge and the
voltage is lower than 13V. The process cycles every 4±0.5h until the
voltage is higher than 13V. If it cycles 5 times and the voltage is still
lower than 13V, there will be a code "F01" present on the display
panel, indicating error. Please replace the battery.
13. Charging State LED – Green LED. When battery is charged at a
constant current or a constant voltage, the green LED will flash.
When the battery goes into float charge, the charger will cut receiving
power to battery for1 minute to check the charging state. At this time,
the green LED will light up. If the battery tests as full charged or goes
into float charge, the green LED will remain lit.
14. Cooling fan – Built-in high-speed cooling fan. When you charge a
battery in the constant current or constant voltage condition, and the
current is higher than 3.5A,or temperature is more than 122°C (50°F),
the fan will run automatically.
15. Engine start button – Use to jumpstart your vehicle's battery if it is
low.
16. 2A Maintainer – Use 2A port to do the battery maintenance.
14