Before Start-Up - Maestro MR800 Owner's Manual

- Perform assembly and disassembly only after full stop of moving
parts.
-Do not insert any
In case of failure to observe the rules a danger of serious
damages may arise!
- THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY. DO NOT
USE THE APPLIANCE FOR ANYTHING OTHER THAN INTENDED
USE.
Purchase industrial devices for commercial use.
Actions in extreme situations:
- If a device tumbled into water, immediately, unplug the device, not
touching to the device or water.
- In case of appearance from appliance of smoke, sparkling, strong
smell of a burn isolation, immediately stop use the device, unplug
the device, appeal to the nearest service center.
Before startup
- Remove all wrap materials and stickers
- Make sure that all the parts of appliance don't have damages.
Attention!
At the time of the first switching on the device, a specific smell or
smoke may appear for a short time. These are normal phenomena
due to the presence of preservation materials on the electric drive
motor. They shall disappear after several minutes of the device
operation.
Before switching on the device, make sure that the switch (H / Fig.
1) is in the position "0" (Disabled/OFF). Connect the device to the
electricity mains 220 - 240 V, 50 Hz. Your juicer is ready for use
6