Oven Installation; Mounting Plate - DCS CMOH-30SS Installation Instructions Manual

10. OVEN INSTALLATION

THIS MICROWAVE OVEN CANNOT BE PROPERLy INSTALLED WITHOUT REFERRING TO THE MOUNTING
INSTRUCTIONS FOUND ON BOTH TEMPLATES.
READ AND FOLLOW MOUNTING INFORMATION ON BOTH TOP CABINET AND WALL TEMPLATES.

MOuNTiNG PlATE

1. Separate 4 Toggle Bolts 2, packed in the INSTALLATION
HARDWARE, from the Toggle Nuts.
2. Use Wood Screws 1 to attach Mounting Plate to the stud or
studs. Use Toggle Bolts to attach Mounting Plate through the
holes at A, B, C and D; UNLESS THOSE HOLES ARE LOCATED
ON THE STUD. Insert one Toggle Bolt into A, B, C and D where
appropriate (these correspond to the holes of the Wall Tem-
plate) and put the Toggle Nuts onto the Toggle Bolts. Figure
18.
Refer to instructions in Wall Template.
3. Position the Mounting Plate with the Toggle Bolts attached
at the wall location and insert Toggle Nuts and Bolts through
the holes in the wall with the Toggle Nuts closed. Figure 19.
Use Wood Screws 1 to attach the Mounting Plate to studs.
Note: Before insertion, be sure you leave a space more than the
thickness of the wall between the Mounting Plate and the end
of each of the Toggle Nuts (in the closed position). If you do not
leave enough space, the Toggle Nut will not be able to open on
the other side of the wall. Also, once a Toggle Nut opens, it can-
not be withdrawn from the hole; therefore make sure all of the
Toggles are in the correct position before insertion.
4. Align the Mounting Plate carefully and hold in position while
tightening Toggle Bolts. Pull Toggle Bolt toward you and turn
clockwise to tighten. Figure 20.
MOuNTiNG OVEN TO THE WAll
Two people are recommended to attach the Microwave Oven/
Hood to the Mounting Plate.
1. Place cut portion of carton (B) on top surface of range. Protec-
tion of the range cooking surface is recommended. A protec-
tive drop cloth may also be used to cover the top of the range.
2. Place carton portion (C) on portion (A); then place oven as
shown in Figure 21.
3. Place the oven and the carton portions together on the top
of the range covered with (B). Slide carton portion (A) toward
backsplash until stops. Align the lower back edge of the oven
with the mounting plate.
6
Mounting Plate
Figure 18
Space more than
wall thickness
Wall
Figure 19
Figure 20
(B)
(A)
Figure 21
(C)