Ventilation System - DCS CMOH-30SS Installation Instructions Manual

8. PREPARATION OF THE
OVEN
1. Rest the microwave oven on its side as shown in Figure 7.
Place portion (C) of the carton underneath to protect the
outercase from being damaged.
2. Remove the two screws which secure the mounting plate to
the rear side of the oven. Remove the mounting plate. The
two screws can be discarded.
Note: If the unit you purchased does not have the mounting
plate attached to the rear side of the oven, please disregard
this section and continue to Section 9.

9. VENTILATION SySTEM

This Microwave Oven/Hood System is designed for adapta-
tion to three types of hood ventilation systems. Select the type
required for your installation.
A. Recirculating — Non-Vented, ductless Opera-
tion
The unit is shipped assembled for recirculating.
Notes:
1. The Exhaust Damper Assembly is not required for recircu-
lating operation.
2. The Charcoal Filter should be replaced every 6 to 12
months, depending on use.
B. Horizontal Exhaust — Outside Ventilation
1. Remove and save the 4 screws from Fan Cover Bracket.
Remove Fan Cover Bracket by sliding it in the opposite
direction of the arrow on the Fan Cover Bracket, as shown in
Figure 8.
2. Lift Hood Fan Unit carefully and slip wires out of cavity. See
Figure 9.
CAUTION: Do not pull or stretch hood fan wiring.
3. Rotate the Hood Fan Unit 180˚ so that the fan blade open-
ings are facing the back of the oven. Note, you will need to
lift the wire over the hood fan unit so the wire will clear. See
Figure 10 (A). Replace Hood Fan Unit into the oven. Be care-
ful not to pinch the wire and the Hood Fan Unit. See Figure
10 (B).
4. Put the wire back into the cavity.
5. Replace the fan cover bracket. Make sure the fan blades
are visible through the rear openings in oven before pro-
ceeding. Attach the fan cover bracket to the unit with the
4 screws removed in step 1 above. See Figure 11. The hood
fan is now rotated for horizontal exhaust operation.
6. Attach the Exhaust Damper Assembly to the back of the
mounting plate by sliding it into the slits in the same direc-
tion as the arrow. See Figure 12. Using tapping screw 4 x 12
mm from the INSTALLATION HARDWARE, tighten into place.
4
Mounting plate
Grease filter openings
Figure 7
Fan Cover Bracket
Figure 8
Figure 9
(A) Rotate 180˚
(B)
Figure 10
Wire Box
Figure 11