Web Configuration - D-Link DWL-810 User Manual

6.

Web Configuration

Configuration is required only if you will be using the DWL-810 in
Infrastructure mode. If you will be using the DWL-810 in Infrastructure mode
or if you need to configure the DWL-810, please consider the following
before using the Web Configuration:
You will need a JavaScript-enabled web-browser such as the Internet
Explorer 4.0 or higher, or the Netscape Navigator 4.0 or higher.
The computer that you are using for initial configuration must have
an IP Address within the same range as the IP Address of the DWL-
810. The DWL-810 has a default IP Address of
subnet mask of 255.255.255.0
You will need to assign a Static IP Address to the computer that you are
using to configure the DWL-810, within the IP Address Range of the DWL-
810. For example, you can assign a Static IP address of 192.168.0.2 with
a subnet mask of 255.255.255.0 (Please see the Pre-Installation or the
Networking Basics sections in this manual for information on Assigning
a Static IP Address.)
After you have assigned a Static IP Address to the computer you are using
for configuration, next you will assign the DWL-810 an IP Address within
the range of your existing network.
You will temporarily lose connection to the DWL-810. In order to regain
connection to the DWL-810, after changing its IP Address, revert to the IP
address that you had for this computer before you began the
configuration, as follows:
•
If this computer had a static IP address re-input that same
address.
•
If the computer had a dynamic IP Address (i.e., a DHCP capable
router automatically assigns the IP Address) then change the setting
of your network adapter to receive a Dynamic IP Address.
No Configuration is needed when you use
the DWL-810 in Ad-Hoc Mode.
16
192.168.0.30 with a