North American (60Hz) Models - Sunrise spas 670 EZ Owner's Manual

NORTH AMERICAN (60HZ) MODELS

Please note the following important information:
When using this electrical equipment, basic safety instructions should be followed, including the following:
Read and Follow ALL Directions
1) Electrical installation must be carried out by a qualified electrician strictly in accordance with local governing
codes.
2) A terminal marked "ground" is located within the control box. To reduce the risk of electric shock this terminal
must be connected to the grounding means provided in the electric supply service panel with a continuous
copper wire equivalent in size to the circuit conductors supplying the equipment.
3) At least two lugs marked "bonding lugs" are provided on the external surface of the control box. To reduce the
risk of electric shock connect the local common bonding grid in the area of the hot tub or spa to these
terminals with an insulated or bare copper conductor not smaller than No. 6 AWG.
4) All field installed metal components such as rails, ladders, drains or other similar hardware within 3m (10 ft.) of
the spa or hot tub shall be bonded to the equipment grounding bus with copper conductors not smaller than
No. 6 AWG.
5) Test the ground fault circuit interrupter before each use of the spa.
6) Before servicing any electrical components of the system make sure that the power supply is switched off.
ATTENTION: ELECTRICIAN & SPA OWNER
This fuse is not replaceable and the entire spa pack is considered destroyed.
LEISURE MANUFACTURING'S COMPREHENSIVE SPA WARRANTY.
Sunrise Spas 2019 Owner's Manual
PICO FUSE
Balboa Spa packs contain a special fuse, referred to a "Pico fuse".
This special fuse is designed to open (burn out) if:
a) There is any problem with how the electrical supply is connected
b) There is a power surge to the spa pack
WARNING!
THIS IS NOT A CONDITION THAT IS COVERED UNDER THE
SPA PACK MANUFACTURER'S WARRANTY OR
13
DOC: OM-SUNRISE-19