Setting The Date And Time - Panasonic VL-SDM200A Operating Instructions Manual

Getting Started
Note:
R In order to maintain battery pack performance and prevent the battery pack from discharging,
remove the battery pack when the Wireless Monitor is off the Base Unit or the power plug is
unplugged from the power outlet for a week or longer.
– Recharge the battery pack before using the Wireless Monitor again.

Setting the date and time

This unit has a recording function. The date and time will not be recorded when recording unless they are
set (page 25). You can set the date and time using the Wireless Monitor.
R The date and time registered to the Base Unit can also be changed on additional Wireless Monitors.
1
Press MMENUN, then select "ALL SETTINGS" by pressing MDN, MCN, MFN, or MEN.
2
Press M N (Monitor button) ("OK"), then select "START-UP SETTINGS" by pressing MDN or MCN.
3
Press M N (Monitor button) ("OK"), then select "TIME AND DATE SETTINGS" by pressing MDN or
MCN.
4
Press M N (Monitor button) ("OK"), then set the current date and time.
Select the year/month/date/hour/minute by pressing MFN or MEN.
Select numbers by pressing MDN or MCN.
R You can scroll numbers by pressing and holding MDN or MCN.
Example:
2012-11-23 11: 45
5
Press M N (Monitor button) ("OK") after finishing the settings.
R A beep will sound when the settings are changed.
6
To finish the operation, press MMENUN 2 times.
Note:
R Time may get out of sync by about 60 seconds per month.
16
PRESS TALK
OK
MENU