Related Manuals for HornBlasters OUTLAW 232
Summary of Contents for HornBlasters OUTLAW 232
- Page 1 OUTLAW INSTALLATION MANUAL 232, 240, 244, 248 WARNING: To ensure the longevity of your system, reading and following these instructions are recommended. Make sure to change filters and to drain the moisture from your tank on a regular basis.
- Page 2 Read over the entire instruction guide before you begin your installation. KIT CONTENTS: • 3 x 18-22 Gauge Butt Connector • 1 x 1/4” Drain Cock • HornBlasters Outlaw Air Horns • 3 x 10-12 Gauge Butt Connector • 1 x 35 Amp Fuse • Viair 325/400/444/480 Air Compressor •...
- Page 3 • Tubing Cutter/Razor • Eye Protection I. INSTALLING YOUR HORNBLASTERS TRAIN HORNS Locate an area for your horns that is dry and free from debris. The horns can be mounted in any direction and still be heard from all around. The horns should not be mounted where they will be completely submerged or will receive any kind of impact.
- Page 4 Hand tighten only, and don’t tighten by twisting the box. www.hornblasters.com support@hornblasters.com...
- Page 5 AIR GAUGE IN TANK: 1. Install the Hornblasters Air Gauge in the last remaining 1/4” NPT port using Teon tape or paste on the threads. Make sure to mount the air pressure gauge on the side or the top of the tank so that condensation will not be able to drain in to the gauge.
-
Page 6: Maintenance & Tips
CAN’T FIGURE IT OUT? No problem! Give us a call at 813-783-8058, or email at support@hornblasters.com and we’ll be more than happy to help you fix your system. Also feel free to visit our online horn community, www.trainhornforums.com, for more information. - Page 7 Trainhornforums.com is the largest train horn community online and provides a place to share photos of your ride, post videos, catch up with other train horn and HornBlasters fans, meet other train horn enthusiasts, or even find help with a complicated question.
- Page 8 Most factory horns are positively activated. If your horn system is negatively activated, then you will need to wire one of the leads from the value to a direct 12v power source. Then wire the other lead to the megatively charged horn wire. www.hornblasters.com support@hornblasters.com...