Advertisement
INSTALL SOAP/LOTION DISPENSER (OPTIONAL)
1.
A
Pull and remove spout
(A) from dispenser body
(B). Remove clamp nut
(C) and brass spacer (D)
from threaded shroud.
B
D
C
4.
G
Slide red tubing (F)
into tube fitting (G)
F
at bottom of spout.
INSTALL AIR SWITCH (OPTIONAL)
1.
A
EXPOSE
THREADS
Before inserting air switch into
hole, loosen switch base (A)
until threads are exposed.
2.
COUNTER
OR SINK
Fit dispenser body through 1-3/8" hole
on counter or sink. (No plumbers putty is
required). Slide brass spacer onto shroud.
Screw clamp nut and tighten snug.
5.
2.
C
Slide clear tubing
(B) into tube
fitting (C) at
B
bottom of air
switch shroud.
3.
1-3/8"
HOLE
Fill plastic bottle with soap or lotion. Thread
bottle (E) into bottom of dispenser shroud.
6.
Insert open end of
red tubing down
through dispenser
base and into
plastic bottle.
3.
1-1/2"
HOLE
COUNTER
OR SINK
Fit air switch and tubing through
1-1/2" hole on counter or sink.
(No plumbers putty is required.
O-ring seals base).
E
Push down on spout
to secure over white
O-rings.
Pump spout a few
times to get soap or
lotion flowing.
4.
D
Slide washer up then screw the
clamp nut onto threaded shroud.
Hand tighten nut to underside of
sink or counter until snug.
CONTINUED ON NEXT PAGE
Advertisement
