BEFORE YOU BEGIN YOUR INSTALLATION:
1
Turn o water supply.
REQUIRED TOOLS:
HANDLE POSITION
Waterstone faucets are designed to be installed in 3 different faucet
positions. Choose to have the handle on left, front or right. Your faucet is
factory configured for the most common positions - a front and right side
installation. To reverse this and have the handle positioned on the left,
connect the hose for cold water to the hot supply and the hose for hot water
to the cold supply. This will maintain the relationship of pulling the handle
for hot water or pushing for cold water.
FAUCET INSTALLATION
1.
C
B
A
Remove clamp nut (A) and
washer (B) from threaded
shroud (C).
2
Observe all local
plumbing codes.
Adjustable Wrench
2.
COUNTER
OR SINK
D
Fit flexible hoses (D) and rigid
sidespray tube (E) through hole on
counter or sink. (No plumbers putty
is required. O-ring seals base).
3
Inspect plumbing for signs of
damage. Replace as necessary.
Phillips Screwdriver
HANDLE ON LEFT
3.
E
Slide washer and thread the
clamp nut onto threaded shroud.
Tighten nut snug to underside of
sink or counter.
4
DO NOT use petroleum based
products on this faucet.
Channel Locks
HANDLE IN FRONT
HANDLE ON RIGHT
4.
Turn faucet to the desired handle
position. Securely tighten clamp
screws (F).
F