Advertisement
HOW TO ADJUST HANDLE POSITION AND HANDLE TENSION
FIG.1
ORIGINAL FACTORY POSITION
MAY HIT BACKSPLASH
On some kitchen countertops, the handle may hit the
backsplash when the faucet handle is positioned to the left
or right (Fig. 1). Waterstone gives you the option of adjusting
the handle 22.5 degrees to avoid hitting backsplash.
CONNECTING SUPPLY HOSES
Before connecting supply hoses, flush
supply stops to clear any debris. Place
HANDLE ON LEFT
HANDLE IN FRONT
a bucket underneath stops and run
water for 5 to 10 seconds. Turn water
off. Carefully position hot and cold
supplies so they will not interfere with
other hoses. Connect supply hoses (A)
to supply stops (B). DO NOT use teflon
tape or plumbers putty. Turn water
back on and check for leaks.
CONNECTING SIDE SPRAY (OPTIONAL)
1.
A
COUNTER
OR SINK
B
C
Insert side spray base (A) into
hole of your sink or counter. (No
plumbers putty is required). Slide
brass spacer (B) onto shroud.
Screw on attaching nut (C) and
securely tighten.
Unscrew and remove metal cap (A) and Hot and Cold Indicator Ring (B). Unscrew and
remove holding screw (C) and washer (D). Hold handle (E) in a vertical position. Wiggle
and pull straight off faucet. Rotate handle 22 degrees away from backsplash then slide
handle back onto valve stem (F). Insert holding screw with washer and tighten. Slide
Hot and Cold Indicator Ring onto handle and thread metal cap back into place. To adjust
handle tension, turn ring (G) clockwise to increase
or counterclockwise to decrease.
NEW ADJUSTED POSITION
CLEARS BACKSPLASH
HANDLE ON RIGHT
A
B
2.
D
Slide sidespray hose (D) through
side spray base.
A
B
OPTIONAL HOT COLD INDICATOR RING
To reverse, or remove Hot and Cold Indicator
A
Ring, unscrew the metal cap, remove ring and
flip. Slide ring back onto handle and screw
H
metal cap back on.
3.
F
E
Turn off water supply. On the
faucet, remove cap (E) from end
of sidespray tube (F).
G
C
D
E
F
F
B
C
C
D
E
RED FOR HOT
BLUE FOR COLD
4.
Connect and tighten sidespray
hose to sidespray tube.
Advertisement
