– Low Battery Alert Indication You have purchased one of the most accurate moisture measurement instruments for wood in the world. Hand-held moisture meters from Wagner Meters have been proven by universities – Auto Shut-Down to Preserve Quick Start: Basic Use for and institutes worldwide to provide superior measurement results.*...
Wagner’s technology has been proven to provide some of the most accurate results in the MENT industry when compared to the ASTM D4442-16 Standard. Wagner meters have been used for (Meter Serial years by professional lumber-grading associations, and meters from Wagner continue to provide Number is reliable and consistent moisture measurements, with unsurpassed convenience and ease of use.
Database. If you still cannot find the correct setting, contact a Wagner Meters expert at material you are measuring. If the sensing area is not completely covered, your moisture 844-689-0660.
Be sure to press down firmly to ensure good sensor plate contact with the surface of the wood meter is ready to take moisture measurements. Be assured that any settings that you have or building material. This is especially important when measuring rough-sawn lumber. previously programmed/selected will be active.
SPECIES/MATERIAL Button Regardless of the mode you choose, when the meter is turned OFF (or shuts off automatically), and then the meter is turned back ON, the meter will be in the mode it was in when it previously The SPECIES/MATERIAL button on your Orion® 920 is used to place your turned OFF.
If the DOWN button is pressed and held for 0.7 seconds, the setting will AUDIO Button decrease to the next multiple of .10 (e.g., if the setting is currently .66, the setting will change to .60). Every 0.7 seconds thereafter that the button is Your Orion®...
SUMMARY OF ORION 920 FEATURES setting is 5% to 32%, in 1% increments (no decimal place). ® Next, press the AUDIO button again, and you will be taken to a display that will show the current volume setting for audible sound. Simply use the UP or •...
Low Battery Alert Indication please be aware that you must ONLY calibrate to the correct Calibrator that came with the meter. Serial numbers on the Calibrator (found underneath) and meter (found in the battery When the battery is low, BAT appears in the upper right-hand corner of the display. If ignored compartment) MUST match for correct calibration.
Press the ON/HOLD button to return the meter to normal measuring mode. Wagner Meters offers an industry-best 7-year warranty on your Orion® 920 moisture meter. If, after recalibrating the Orion® 910, there is still a problem with the meter, please contact a Wagner representative for further instructions at 844-689-0660.
SPECIFICATIONS CHANGING THE BATTERY As indicated earlier in this manual, if BAT appears on the display, the battery must be changed Dimensions with Boot immediately or any further moisture measurements will be inaccurate. Replace with 9-volt, • Length: 5.75 inches (146mm) non-rechargeable Alkaline or Lithium or rechargeable NiMH batteries.
Technical Support/Repair Contact With proper care and maintenance, the meter should stay in calibration; however, because Wagner Meters has no control over the manner in which the unit will be used, it makes no Worldwide Toll-Free: 844-689-0660 guarantee that the meter will stay in calibration for any specific period of time. Wagner Meters recommends returning the unit to the factory for a diagnostic checkup in the event the meter is dropped or otherwise damaged.