1. Manuals
  2. Brands
  3. Wagner Meters Manuals
  4. Measuring Instruments
  5. Orion 910
  6. Instruction manual

Wagner Meters Orion 910 Instruction Manual

Moustre meter
Hide thumbs Also See for Orion 910:
Table of Contents

Advertisement

Quick Links

Download this manual
INSTRUCTION MANUAL

Advertisement

Table of Contents
loading

Related Manuals for Wagner Meters Orion 910

Summary of Contents for Wagner Meters Orion 910

  • Page 1 INSTRUCTION MANUAL...

  • Page 2: Table Of Contents

    TABLE OF CONTENTS 22 Summary of Orion® 910 Features – Low Battery Alert Indication –Auto Shut-Down to Preserve Introduction Battery Life Orion® 910 Parts – Calibration of your Orion® 910 –Protective Rubber Boot for Your Quick Start: Basic Use for Orion®...

  • Page 3: Introduction

    INTRODUCTION The 2.0-inch (50mm) wide by 2.5-inch (63mm) long by .75-inch (19mm) thick sensor field of your Orion® moisture meter closely approximates the full- Congratulations! thickness cross-section method used when You have purchased one of the most accurate performing the ASTM D4442-16 oven-dry moisture measurement instruments for wood lab method.

  • Page 4: Orion 910 Parts

    PLATE moisture measurements, with unsurpassed convenience and ease of use. BATTERY COMPART- MENT *Information available upon request.**Contact a Wagner Meters expert at 844-689-0660 if your (Meter Serial wood is very hot or frozen. Number is located in this compartment)

  • Page 5: Quick Start Basic Use For Solid Wood

    Wagner’s extensive Species Database. If you still cannot find the in the air. If meter display does not display 0.0%, then refer to page 15 regarding the correct setting, contact a Wagner Meters expert at 844-689-0660. SPECIES/MATERIAL button. Next, press the SPECIES/...

  • Page 6: Correct Usage Guidelines For

    To make sure that you are getting the most Usage Guidelines section of this manual). accurate readings from your Orion® 910 meter, Wagner Meters recommends that When you are finished you pay close attention to the following taking measurements and...
  • Page 7 If you wish to measure wood pieces If there is visible moisture or water with thicknesses less than .75 inches on the surface of the wood or material (19mm), the meter will underestimate to be tested, wipe off any excess, and the actual moisture content.

  • Page 8: Function Buttons: Detailed

    ACQ, or any other treatment with metallic When in the Standard Measurement mode, or other components that might bias the pressing and releasing the ON/HOLD moisture readings. button will freeze whatever reading is showing on the display. Additionally, the word HOLD will show in the upper FUNCTION BUTTONS: right-hand corner.

  • Page 9: Up And Down Buttons

    UP and DOWN Buttons mode, the meter display will indicate settings values from 0.20 up to 1.00. The particular settings mode Factory default is 0.50. (SPECIES/MATERIAL or AUDIO) that you are in at Relative Measurement mode. Used a given time will determine for obtaining relative, rather than how these buttons will absolute, measurements, typically for...

  • Page 10: How To Program A Species Setting

    3-digit number such as 0.50, etc.), you can measure, go to www.wagnerspecies.com. use the UP or DOWN arrows to program If you still cannot find the correct setting, contact Wagner at 844-689-0660. the meter for the correct setting. If you need to change modes, press and release the SPECIES/MATERIAL button.

  • Page 11: Relative Scale For Moisture

    down, the setting will change by another .10 mode. Once in Standard (e.g., from .40 to .50). Measurement mode, 0.0 will be displayed on the If the DOWN button is screen if the meter is held pressed and held for 0.7 in the air.
  • Page 12 AUDIO Button seconds thereafter that the button is held down, the setting will change by another Your Orion® 910 AUDIO 5 units (e.g., from 15% to 20%). If the button allows you to set a DOWN button is pressed and held for high moisture content alarm 0.7 seconds, the setting will decrease to threshold (setting from 5% to 32%) for solid...
  • Page 13 SUMMARY OF Next, press the AUDIO ORION® 910 FEATURES button again, and you will be taken to a display that will show the current • Digital display resolution of 0.1% volume setting for audible (in Standard Measurement mode) sound. Simply use the UP or DOWN •...

  • Page 14: Low Battery Alert Indication

    Low Battery Alert Indication Calibration of Your Orion® 910 When the battery is low, BAT appears in If you have reason to believe your Orion® the upper right-hand corner of the display. 910 may be out of calibration, it can be easily If ignored for too long, the meter will recalibrated using the provided Calibration flash a larger BAT three times and then...

  • Page 15: Protective Rubber Boot For Your Orion® 910

    5 seconds until the word the edges against other hard DONE appears on the display. During objects, Wagner Meters this last phase in the air, be sure to keep has provided a fitted rubber boot which your hand and other objects away from the fits snugly around the perimeter of your underside of the meter.

  • Page 16: 7-Year Warranty

    This protective boot should remain in 7-Year Warranty place at all times even when calibrating your meter on the Calibration Reference.* Wagner Meters offers an industry-best All function buttons as well as the 7-year warranty on your Orion® 910 display screen, sensing plate, and battery moisture meter.

  • Page 17: Wagner's Intellisense

    SPECIFICATIONS Wagner’s IntelliSense Technology Your Orion® 910 moisture meter features Dimensions with Boot Wagner’s IntelliSense technology, going • Length: 5.75 inches (146mm) beyond the surface conditions for accurate • Width: 3.0 inches (76mm) measurements of moisture conditions • Thickness: 1.0 inches (25mm) inside the wood.

  • Page 18: Changing The Battery

    Replace with 9-volt, non-rechargeable Wagner Meters’ warranty offers this product Alkaline or Lithium or rechargeable NiMH protection against defects in material and batteries. Be sure to observe proper battery workmanship for seven (7) years from the date polarity.
  • Page 19 Wagner Meters has no control over PURPOSE. Under no circumstances shall the manner in which the unit will be used, Wagner Meters be liable for any incidental or it makes no guarantee that the meter will consequential damages. Agents and employees...
  • Page 20 Notes Notes...
  • Page 21 Rogue River, OR 97537 Worldwide Toll-Free: 844-689-0660 WWW.WAGNERMETERS.COM ©Wagner Meters 2018 All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of the publisher.

Table of Contents