Connecting The Network Cable - D-Link DFE-550TX User Manual

D-Link DFE-550TX Adapter
the WOL cable.
1. Connect either end connector of the WOL Cable to the
NIC WOL Connector. Both ends of the WOL Cable are
identical, so either end may be used.
2. Examine the PC motherboard and/or refer to the
manual for the
corresponding WOL Connector on the motherboard.
The actual location is system dependent, but the
motherboard may have a label beside the WOL
Connector. After you have located the WOL connector
on the motherboard, connect the cable.
3. Power-ON the PC and press <Delete> or <F1> when
prompted to enter the PCI/ISA BIOS CMOS Setup.
Enable the WOL function or the power-ON function of
the PC. The name of this function is system
dependent, but may be located in a category heading
titled something like Power Management. Refer to
your computer's
regarding the CMOS Setup Utility and BIOS settings.
NOTE: If your system's motherboard WOL Connector does not fit the
WOL Cable or does not have 3 pins, do not attempt to force a
connection or alter the components to fit. Doing so could
permanently damage your computer.

Connecting the Network Cable

Category 5 UTP cable qualifies for both 100BASE-TX Fast
Ethernet and 10BASE-T Ethernet cabling rules. The maximum
length of any single cable segment is 100 meters. Please keep in
mind, however, that the maximum cable run between any two
stations in a collision domain is 205m.
8
motherboard to locate
manual for more information
the