D-Link Air DCF-660W Quick Install Manual page 5

Select the "Configuration" tab (Fig. 3.3). By
default, it will display current wireless settings:
SSID - (Service Set Identifier) is a name that
identifies a wireless network. Access Points and
wireless clients attempting to connect to a specific
WLAN (Wireless Local Area Network) must use the
same SSID. The default setting is default.
Specifying an SSID will prevent you from inadvertently
connecting to a different wireless network.
Network Type – Use "Infrastructure" mode if you
will be using a Wireless Router or Access Point in
your network. Use "Ad-hoc", if you will not be
using an Access Point. Ad-hoc requires the same
channel and the same SSID for wireless devices on
the wireless network.
Power Saving Mode – The "Power Save" mode is used to extend battery life.
Note: In "Power Save" mode, the associated Wireless Router or the Access Point must support
" Power Saving" for communication to be established.
Tx Rate – The default transfer rate of "Auto" which allows the DCF-660W to adjust
to the most optimal transfer rate available. However, the settings can be set at a fixed
t
ransfer rate.
If any changes are made in this section, select Apply to save changes.
For detailed explanation on the Ad-Hoc, Infrastructure mode, wireless basics,
and troubleshooting, please refer to the DWL-660W Manual.
T he Wireless configuration of the
D CF-660W is now complete
Note:
Fig. 3.3
5