D-Link Air DCF-660W Quick Install Manual page 4

Configuring the DCF-660W Wireless Settings
After resetting the PDA, the DCF-660W Compact Flash Adapter will finalize
its driver installation and the Settings screen
(Fig. 2.1) will appear. This section allows
users to set the IP address released from the
Wireless Router or Access Point.
If the Settings screen does not appear, go to
Start > Settings > Connections and select
on IP Address icon tab. Select Use server-
assigned IP (dynamic IP) address via
DHCP or assign a specific IP address
(static IP) and click ok.
Check to see if the Wireless Router or Access
Point has a DHCP server built in. If DHCP
server is not available, select
"Use specific IP address" and enter in
the proper Static IP address, Subnet mask
and Default gateway information to access the
Wireless router or Access Point.
By default the DCF-660W is set to "Use
server-assigned IP address."
To configure the SSID (Service Set
Identifier) and Network Type, go to Start >
Settings > select System tab > click on
DCF-660W CF Card icon.
Fig. 3.1
Fig. 3.2
4