An 802.11b Access Point (e.g., DWL-1000AP for Infrastructure mode) or another 802.11b wireless adapter (e.g., DWL-650 for Ad-Hoc mode.) The default settings for the DCF-660W will work out of the box when used with D-Link Air and D-Link Air Plus Wireless Routers and Access Points.
Insert the driver CD that came with your DCF-660W into the CD- ROM drive on your computer. Click on Install Drivers as shown on the right. (Insert Autorun SS) If the Autorun function on your laptop computer does not automatically start, proceed to the steps below.
Click Yes Fig. 1.4 Click OK Fig. 1.5 Click Finish Fig. 1.6 Driver installation is now complete Now, proceed to Section 3 to properly configure the wireless settings for the DCF-660W. Reset the PDA to finalize the DCF-660W driver installation.
Configuring the DCF-660W Wireless Settings After resetting the PDA, the DCF-660W Compact Flash Adapter will finalize its driver installation and the Settings screen (Fig. 2.1) will appear. This section allows users to set the IP address released from the Wireless Router or Access Point.
“ Power Saving” for communication to be established. Tx Rate – The default transfer rate of “Auto” which allows the DCF-660W to adjust to the most optimal transfer rate available. However, the settings can be set at a fixed ransfer rate.
Wireless Router or Access Point WEP encryption. Q: The DCF-660W link light is not on. A: Check to see if the DCF-660W CF adapter is firmly inserted into a type I or II slot in the PDA.
Contacting Technical Support Thank you for purchasing D-Link Air DCF-660W. For any questions or assistance using the DCF-660W, please feel free to contact technical support. The most recent software and documentation are available on the D-Link website. D-Link provides free technical support for customers within the United States during the warranty period on this product.
Building Networks For People...