Elecom Kasane M-NE3DL Series User Manual

5-button wireless laser mouse
M-NE3DL Series
User's Manual
Thank you for purchasing the ELECOM M-NE3DL Series 5-button wireless laser mouse.
This manual describes the operating instructions and safety precautions for using the M-NE3DL
Series. Ensure that you have read this manual before using the product. After reading this
manual, store it somewhere safe for future reference.
* Except in certain cases, the M-NE3DL Series is referred to as "this product" in this manual.
Safety Precautions
WARNING
Meaning of symbols Do not attempt to disassemble, modify
„
or repair this product by yourself, as this
Failure to observe precautions
may cause a fire, electric shock or product
may result in serious personal
WARNING damage.
injury or death due to fire,
Do not put this product in fire, as the
electric shock, or other causes.
product may burst, resulting in a fire or
Failure to observe precautions
injury.
may result in personal injury
CAUTION Do not connect or disconnect the receiver
due to electric shock or other
unit with a wet hand, modify the receiver
causes, and may damage
unit or bend it forcibly, as this may cause a
other equipment.
fire or electric shock.
Prohibited action
The receiver unit contains small parts that
could be swallowed by a child. Ensure that
Mandatory action
the unit is stored in an area where it is not
Situation that needs attention accessible to children.
Notes and reference information
CAUTION
Observe these precautions carefully to avoid
Do not place this product in any of the
personal injury, damage, fire, and other problems.
following environments:
WARNING
• In a car exposed to sunlight, a place exposed
to direct sunlight, or a place that becomes
If a foreign object (water, metal chip, etc.)
hot (around a heater, etc.)
enters the product, immediately stop using
• In a moist place or a place where condensation
the product and disconnect the receiver
may occur
unit from the PC, and remove the battery
• In an uneven place or a place exposed to
from the mouse. If you continue to use the
vibration
product under these conditions, it may
• In a place where a magnetic field is generated
cause a fire or electric shock.
(near a magnet, etc.)
If an abnormality is found with this product • In a dusty place
(emission of heat, smoke or abnormal smell
This product does not have a waterproof
from the product), immediately stop using
structure. Use and store this product in a
the product, shutdown the PC, and after
place where the product body will not be
thoroughly checking that heat from the
splashed with water or other liquid.
product will not cause burns, disconnect
Rain, water mist, juice, coffee, steam or
the receiver unit from the PC, and remove
sweat may also cause product damage.
the battery from the mouse. After doing
this, contact the retailer from whom you
purchased the product.
When you no longer need to use this
produc t and the batter y, be sure to
Do not drop or hit this product.
dispose of it in accordance with the local
If this product is damaged, immediately
ordinances and laws of your area.
stop using the product and disconnect the
receiver unit from the PC, and remove the
battery from the mouse.
If you continue to use the product under
these conditions, it may cause a fire or
electric shock.
Batteries
„
Part Names
CAUTION
Mouse
„
For this product, use AAA alkaline batteries, AAA

manganese batteries or rechargeable AAA nickel hydride 

batteries.
If this product will be unused for a long period of time,
remove the battery to avoid battery leakage and failure.
Cleaning the Mouse
„
If the product body becomes dirty, wipe it with a soft, dry cloth.

Use of a volatile liquid (paint thinner, benzene, alcohol,

etc.) may affect the material quality and colour of the
product.
Receiver unit
„
Cautions for Wireless Equipment
This product is wireless equipment using the entire range of the 2.4 GHz
band and it is possible to avoid the band of mobile object identification
systems. GFSK is used for the radio wave method. The interference
distance is 10 m.
 Left button
The 2.4 GHz band is also used by medical equipment, Bluetooth, and
Used for left-click operation.
wireless LAN equipment conforming to the IEEE802.11b/11g/11n
 Right button
standard.
• Before using this product, check that there are no other "radio
Used for right-click operation.
stations"* operating nearby.
 Tilt Wheel
• If electromagnetic interference occurs between this product and
The tilt wheel can be turned back and forward with your
other "radio stations", move this product to another location or stop
finger or pressed like a button to operate the PC.
using this product.
Tilting the tilt wheel to the right or left lets you scroll
* Other "radio stations" refer to industrial, scientific and medical devices
horizontally.
using the 2.4 GHz band like this product, other radio stations of this
type, licensed radio station premises for mobile object identification You must download and install ELECOM MouseAssistant
system that is used in factory production lines, certain non-licensed 2 for Windows from ELECOM website to use the high-
low power radio stations and amateur radio stations. speed scrolling function and the horizontal scrolling
function with Windows.
Using the horizontal scrolling and button allocation
WARNING
functions (See reverse)
● Do not use this product with a device that may have a
d Forward button/ e Back button
serious function or influence. There are rare cases where
an external radio wave at the same frequency or the
radio wave emitted from a mobile phone causes this
product to malfunction, slow down, or fail to operate.
●
Do not use this product in a hospital or other locations
where the use of radio waves is prohibited. The radio
Push the buttons in
waves of this product may affect electronic and medical
from the side direction.
devices (e.g. pacemaker).
●
The use of a wireless mouse in an aircraft is prohibited by
aviation law because doing so may interfere with flight
safety. Turn off the power of the mouse body before
boarding an aircraft and do not use it in the aircraft.
* ELECOM is not liable for any accident or social
damages incurred by the failure of this product.
Preparation before Use
Cautions for Laser Mouse
Installing·Replacing the Battery
Though this product complies with the IEC60825-1 Class 1 laser
safety standard to ensure safety, pay special attention to the Before using this product, install two AAA batteries in the mouse
following before use.
body.
Remove the battery cover.
(1) Never observe the laser beam by using an optical measure
such as a microscope or magnifier or view the laser with the
naked eye for a long period of time. Doing so may have an
adverse effect on the eye. (Some laser beams cannot be seen
with the naked eye.)
(2) Never aim the rear surface of the mouse at a person's eyes, as
this is very dangerous.
(3) The laser sensor may not work on glass or mirrored surfaces.
Insert the batteries.
(4) Do not use this product for any application other than as a PC
mouse.
Make sure that the
y
(5) If this product is subjected to temperatures beyond its
polarity is correct.
specifications, turn off the PC, and do not use the product
until the temperature returns to the operable range.
(6) If this product is not operating normally, turn off the PC.
Install the battery cover as
before.
Package Contents
This product's packaging contains the items listed below. Before
Replacing the Battery
„
using the product, check that all items are present. We make
every effort to ensure that all products are packaged correctly. Remove the battery cover.
However, in the event that an item is missing or damaged,
Remove the batteries using
contact the retailer from whom you purchased the product.
the battery removal sheet.
• Mouse x1
Insert the batteries.
• Receiver unit x1
• AAA alkaline battery x2
• User's Manual x1
Do not mix different types of batteries or
use old batteries with new batteries to avoid
battery leakage and failure.
Install the battery cover as before.






Forward button Back button
Proceeds to the next Returns to the previous
browser screen browser screen

To use the Back and Forward buttons with a Mac, you need
to install the ELECOM Mouse Assistant 2 Mac OS X version
that can be downloaded from the ELECOM website.
Using the button allocation functions (See reverse)
 Remaining battery level indicator lamp
Indicates when to replace the batteries.

* When power is on, the lamp temporarily lights green to
indicate that there is sufficient battery life, and begins
flashing when battery life is low. If battery life becomes low
during use, the lamp will temporarily flash green.
 Receiver unit housing
Used to store the receiver unit.
 Battery cover
This cover is removed to install batteries.
 Battery housing
Batteries are inserted here.
 Battery removal sheet
Used to remove the batteries from the battery housing.
 Laser sensor
When the mouse body is moved, this sensor detects mouse
movement.
* Avoid looking directly at the light of the sensor as doing so
may cause eye damage. Some laser beams cannot be seen
with the naked eye.
Forward button  Power switch
Performs the forward
Used to turn the mouse body on and off.
action in a web browser.
 USB connector (Male)
Back button
Connected to a PC USB port.
Performs the back
action in a web browser.
Turning On and Off the Mouse
Turning on the mouse
„
When using this product, turn the mouse body
power on.
Slide the power switch to the ON position.
The remaining battery level indicator lamp is illuminated in red for a
certain period.
* When the remaining battery level is low, the remaining battery
level indicator lamp is flashed in green for a certain period.
„ Turning off the mouse
When not using this product, turn the mouse body
off to save battery power.
Slide the power switch to the OFF position.
„ Restoring from sleep state
Click the right mouse button.
To reduce battery drain, the mouse enters sleep mode
automatically if it is left without being operated for a certain
period of time with the power or switch turned on.
Inserting and Taking Out the Receiver Unit
Inserting the receiver unit
„
Place the receiver unit into the
receiver unit housing.
Taking out the receiver unit
„
Take the receiver unit out of the
receiver unit housing.
- 1 -
When using Windows®
1 3
S Check USB ports S Checking wheel operation
tep tep
Check the USB port on your computer. Check that the mouse scrolls up and down correctly in
Windows® Internet Explorer.
Display your favourite web site in Internet Explorer
USB port
and change the size of the window so that the
vertical scrollbar appears
y Any USB port may be used.
* The sample website used here is the ELECOM homepage.
y This product can be connected to a USB hub.
However, it may not work depending on the power
supply capability of the USB hub.
2
S Installing the Receiver Unit
tep
Activate the PC.
● If Windows® prompts you to choose an account (a user
Scroll the tilt wheel back and
name) when it starts up, be sure to log on using an
forth. The mouse is operating
administrator account.
normally if the screen moves
● Wait until Windows® has started up completely.
up and down as you scroll the
Insert the receiver unit into the USB port of the PC.
tilt wheel.
Insert here. In applications that do not support scrolling, the
screen will not move when you scroll the tilt wheel.
USB port
In order to use this product's horizontal scrolling
function, you must download and install ELECOM
Receiver unit
MouseAssistant 2 for Windows from our company's
web site.
Carefully check the orientation of the
y
Proceed to "Using the horizontal scrolling and button
connector and the place where you will
allocation functions" on the reverse of this sheet.
connect the receiver unit.
If you feel strong resistance when inserting
y
Click either of the links on the page to proceed to
the receiver unit, check that the shape and
the next page.
orientation of the connector is correct. Using
excessive force may damage the connector Operation is normal if pressing the Back button (
and cause injury. takes you to the previous page and pressing the Forward
button (
The mouse driver is installed automatically.
In certain applications, the function will not work
when you press the Back or Forward buttons.
When using Mac OS X
1 3
S Check USB ports S Checking wheel operation
tep
tep
Check the USB port on your computer. Check that the vertical and horizontal scrolling functions are
working correctly in Safari.
Click the Safari icon in the Dock.
USB port
Safari will launch.
y Any USB port may be used. If Safari is not in the Dock, double-
y This product can be connected to a USB hub. However, click the Safari icon in the Applications
folder.
it may not work depending on the power supply
capability of the USB hub.
Display your favourite web site in Safari and
change the size of the window so that the vertical
2
S Installing the Receiver Unit
tep and horizontal scrollbars appear.
* The sample website used here is the ELECOM homepage.
Activate the Macintosh.
● Wait until Mac OS X has started up completely.
Insert the receiver unit into a USB port on your
Macintosh.
Insert here.
Scroll the tilt wheel back and forth.
USB port
Receiver unit
y Carefully check the orientation of the connector
and the place where you will connect the receiver
unit.
In applications that do not support scrolling, the
y
If you feel strong resistance when inserting the
y
screen will not move when you scroll the wheel.
receiver unit, check that the shape and orientation
To use the Back and Forward buttons with a Mac,
y
of the connector is correct. Using excessive force
you need to install the ELECOM Mouse Assistant 2
may damage the connector and cause injury.
Mac OS X version that can be downloaded from the
y Do not directly touch the USB connector terminal.
ELECOM website.
The mouse driver is installed automatically. Proceed to "Using the horizontal scrolling and button
allocation functions" on the reverse of this sheet.
„ Disconnecting the receiver unit
Operation may become unstable if the receiver unit is
This product is hot-pluggable. It is possible to disconnect the disconnected and reconnected several times when PC is
receiver unit when PC is running. running. If this occurs, restart PC.
Scrollbar
)
) takes you to the next page.
Scrollbar