Air Conditioner Features - PA 4PMC5000 User Manual

AIR CONDITIONER FEATURES

WARNING
To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS before
operating this appliance.
NOTE :
After the air conditioner is turned off, leave the unit OFF for a minimum of 3 minutes before attempting to turn back on.
The cool circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. This allows pressure
inside of the compressor to equalize and prevents overheating as well as possible circuit breaker tripping. Failure to
follow these instructions may be harmful to your unit.
To begin operating the air conditioner, follow these steps:
1. Set the thermostat ("TEMPERATURE") to the highest number (coldest or cooler setting).
2. Set the Cooling knob to the highest COOL setting.
3. Adjust the louver for comfortable air flow. (See "Air Directional Louvers" below.)
4. Once the room has cooled, adjust the thermostat to the setting you find most comfortable.
5. Make sure that the air flow inside and outside are not obstructed.
AIR DIRECTIONAL LOUVERS:
CONTROL PANEL:
9
Lever
The controls featured in this manual are representative of many available models. Your
model may offer slightly different features.
COOL MODE
The desired cool setting is selected by rotating the Cooling knob to the
appropriate location.
"HI COOL" has a maximum cooling effect and airflow.
"LO COOL" has a minimum cooling effect and airflow.
"OFF" will completely shut off the unit.
FAN MODE
Rotate the Cooling knob to select your choice of fan speeds for air circulation.
NOTE: When selecting a fan speed, the compressor will NOT run.
THERMOSTAT
The thermostat ("TEMPERATURE") knob is used to set the desired room temperature
when the unit is being operated in the COOL mode.
To set the desired room temperature, rotate the thermostat ("TEMPERATURE")
OFF
knob to the desired setting. After the set temperature is achieved, the thermostat
will automatically start and stop the compressor in order to maintain the desired set
temperature.
Rotate the thermostat ("TEMPERATURE") knob clockwise for higher cool settings. "MAX
COOL" and/or higher cool settings will provide lower room temperatures. Rotate the
thermostat ("TEMPERATURE") knob counter clockwise for lower cool settings. "MIN
COOL" and/or lower cool settings will maintain higher room temperatures.
The louvers will allow you to direct the air flow Left or Right
throughout the room as needed.
Move the Lever(s) from side to side until the desired Left/
Right direction is obtained.