Table of Contents
Advertisement
1.
Safety Instructions and Storage/ Battery Care
1.1 Safety Instructions
SAVE THESE INSTRUCTIONS.
This manual contains important instructions that should be followed during
installation and maintenance of the UPS and batteries.
1.
Do not open the case as there are no serviceable parts inside. Opening the
case will void your warranty and introduces the risk of electric shock.
2.
Do not try to repair the unit yourself. Doing so will void your warranty. Contact
your local supplier for repairs.
3.
If liquids are spilt onto the UPS or foreign objects dropped into the unit the
UPS could be damaged, users could be subject to electric stock, and the
warranty will become null and void.
4.
Do not install the UPS in an environment with sparks, smoke, or hazardous
gas.
5.
This UPS is equipped with an EMI filter. To prevent potential leakage current
hazards ensure that the AC mains supply is securely grounded. Because of
small leakage currents generated by the EMI filter in the UPS it is necessary
to double check that the ground wire of the UPS is properly grounded before
connecting the UPS to the AC mains
6.
This UPS is designed to be installed and commissioned in a sheltered,
controlled environment as follows:
- Ensure that the UPS is installed within the proper environmental range. (0-
40°C and 0-90% non-condensing humidity). High ambient temperature
reduces battery life.
- Do not install the UPS in direct sunlight. Your warranty may be void if the
batteries fail
- Do not install the UPS in an inflammable or otherwise hazardous
environment.
- Avoid vibration and areas subject to physical impact.
- Avoid any area with sparks.
- Dusty, corrosive, and salty environments can damage any UPS.
- Install the UPS indoors as it is not designed for installation outdoors.
7.
To prevent overheating of the UPS keep all ventilation openings free from
obstruction, and do not place anything on top of the UPS. Keep the UPS rear
panel 20 cm away from the wall or other obstructions.
8.
Install the UPS in a ventilated area, ideally exchanging 5 m
because the chemical reaction during battery charging causes trace gas
production. If the batteries suffer breakage electrical arcing could occur in the
UPS interior.
2
3
of air per hour,
Advertisement
Table of Contents
