Table of Contents
Advertisement
3
Installation
Transportation
Instructions
1. The appliance should be
transported only in a vertical upright
position. The packing as supplied
must be intact during transportation.
2. If during the course of
transport the appliance has to be
transported horizontally, it must only
be laid on its right hand side when
standing in the front of the appliance.
After bringing it to upright position,it
must not be operated for at least 4
hours to allow the system to settle.
3. Failure to comply with the
above instructions could result in
damage occuring to the appliance.
The manufacturer will not be held
responsible if these instructions are
disregarded.
4. The appliance must be
protected against rain, moisture and
other atmospheric influences.
5. Empty any water in the drain
tray before moving see section
"Defrosting" and "Cleaning & Care" for
further information
Important :
Make sure the plastic evaporating
pan at the back of the product collects
water properly.
Important : Care must be taken
while cleaning / carrying the appliance
to avoid touching the bottom of the
condenser metal wires at the back of
the appliance as you might injure your
fingers and hands.
Important :
This appliance is not designed for
stacking with any otherappliance.
When positioning your appliance,
take care not to damage your flooring,
pipes,wall coverings etc. Do not move
the appliance by pulling by the door or
handle.Do not attempt to sit or stand
on top of your appliance as it is not
designed for such use. You could injure
yourself or damage the appliance.
Important :
Make sure that mains cable is not
caught under the appliance during and
after carrying / moving the appliance,
to avoid the mains cable becoming cut
or damaged."Do not allow children to
play with the appliance or tamper with
the controls.
BEKO declines to accept any liability
should
the
followed.
Installation Instructions
1. If possible avoid placing the
appliance near cookers, radiators or in
direct sunlight as this will cause the
compressor to run for long periods. If
installed next to a source of heat or
refrigerator, maintain the following
minimum side clearances:
From Cookers 2" (50 mm)
From Radiators 12" (300 mm)
From Refrigerators or Larder Fridge
1" (25 mm)
2. No gap is required at sides
and top. See item 3 below to ensure
a gap is obtained at the rear of the
appliance. If a gap is available on side
and top, retain it if possible as it would
9
EN
instructions
not
be
Advertisement
Table of Contents
