Table of Contents
Advertisement
3
Installation
Transportation
Instructions
1. The appliance should be
transported only in a vertical upright
position. The packing as supplied
must be intact during transportation.
2. If during the course of
transport the appliance has to be
transported horizontally, it must only
be laid on its right hand side when
standing in the front of the appliance.
After bringing it to upright position,it
must not be operated for at least 4
hours to allow the system to settle.
3. Failure to comply with the
above instructions could result in
damage occuring to the appliance.
The manufacturer will not be held
responsible if these instructions are
disregarded.
4. The appliance must be
protected against rain, moisture and
other atmospheric influences.
5. Empty any water in the drain
tray before moving see section
"Defrosting" and "Cleaning & Care" for
further information
Important :Make sure the plastic
evaporating pan at the back of the
product collects water properly.
Important :Care must be taken while
cleaning / carrying the appliance to
avoid touching the bottom of the
condenser metal wires at the back of
the appliance as you might injure your
fingers and hands.
Important :This appliance is not
designed for stacking with any other
appliance.When positioning your
appliance, take care not to damage
your flooring, pipes,wall coverings
etc. Do not move the appliance by
pulling by the door or handle.Do not
attempt to sit or stand on top of your
appliance as it is not designed for
such use. You could injure yourself or
damage the appliance.
Important :Make sure that mains
cable is not caught under the
appliance during and after carrying
/ moving the appliance, to avoid
the mains cable becoming cut or
damaged."Do not allow children to
play with the appliance or tamper
with the controls.
Beko declines to accept any liability
should
the
followed.
Installation Instructions
1. The space in the room where
the appliance is installed must not be
smaller than 10 cubic metres.
2. If possible avoid placing the
appliance near cookers, radiators or in
direct sunlight as this will cause the
compressor to run for long periods. If
installed next to a source of heat or
refrigerator, maintain the following
minimum side clearances:
From Cookers 2" (50 mm)
From Radiators 12" (300 mm)
From Refrigerators or Freezers
(25 mm)
3. Make sure that sufficient room
is provided around the appliance to
ensure free air circulation. Allow
a minimum of 60 mm (2.4 inches)
between the top of the appliance and
the ceiling or the underside of a wall
cupboard.
8
EN
instructions
not
be
1"
Advertisement
Table of Contents
