D-Link GamerLounge DGL-4300 Quick Install Manual

Existing Network > New Network
Vertical Stands and Rubber Feet
Vertical stacking stands are provided so you can place your D-Link
Gaming Router in a vertical position. Rubber Feet are provided to
allow proper ventilation when the D-Link Gaming Router is placed
®
horizontally or stacked upon other D-Link
To attach the vertical stands, simply slide the vertical stands into the slotted
grooves on the top and bottom panels of the D-Link
To attach the rubber feet, simply press the rubber feet into the
four corners on the bottom panel of the D-Link

Hardware Installation

TCP/IP Settings
1
IP Address:
____.____.____.____
Subnet Mask:
____.____.____.____
2
Default Gateway:
____.____.____.____
Primary DNS:
3
____.____.____.____
Secondary DNS:
____.____.____.____
4
PPPoE Settings
Name:
__________________
Password:
__________________
5
6
7
8
9
10
®
® stackable products.
Gaming Router.
®
Gaming Router.
®
Unplug the power from your broadband modem and
shut down your computer.
Disconnect the Ethernet cable connected from your
computer to your broadband modem. Leave the end
connected to your broadband modem attached.
Connect the end of the Ethernet cable removed from
your computer to the WAN port on the router.
Connect the provided Ethernet cable from a numbered
port on the router to your computer.
Plug the power back into your broadband modem and
wait for the broadband modem to sychronize to the
network (refer to the Modem manual for information
on this).
Plug the power adapter (provided with the router) into
the router, then connect the other end to a power outlet
and verify that the POWER LED on the router is on.
Note: If the Power LED is not lit, verify that the power
adapter is properly connected to the D-Link
Router and to a working power outlet.
Power on your computer.
Verify that the WAN and LAN port (corresponding to
where the computer was connected in step 4) LED's
are on.
Note: If the WAN LED is not lit, check the connection of
the Ethernet cable from the Broadband modem to the
WAN port of the D-Link Gaming Router as detailed in
®
steps 2-3. If the LAN LED is not lit, check the connection
of the Ethernet cable as detailed in step 4.
Launch your web browser and type in a web address
such as http://games.dlink.com to verify that you have
an Internet connection.
Ifawebaddressisnotaccessible,enterhttp://192.168.0.1
in your web browser address bar. Once the main screen
appears, press the button labeled Internet Connection
Setup Wizard and proceed through the wizard.
© 2004 D-Link Systems, Inc. All rights reserved. Trademarks or registered trademarks are the property of their respective holders. Software and specifications subject to change without notice. Version 1.0 Revised 11/25/2004

Wireless Antenna

Attach the wireless antenna to the rear panel of the DGL-4300 by
turning the knob at the base of the antenna until it is fully attached.
Gaming
®
For additional details on the Internect Connection Setup Wizard, please refer to the User Manual on the CD-ROM