Rear View Camera; Using An External Component Via Ads Adapter-Oem Features - Kenwood DDX396 Instruction Manual

Other External Components Other External Components

Rear view camera

Install the rear view camera (separately purchased) in
the appropriate position according to the instructions
supplied with the rear view camera.
Connecting a rear view camera
See page 57 for more information.
• To use the rear view camera, a reverse lead (REVERSE)
connection is required. (Page 56)
Using the rear view camera
• For rear camera settings, see <Rear Camera> on
page 45.
To display the rear view camera screen
The rear view screen is displayed by shifting the gear
to the reverse (R) position when <Rear Camera
Interruption> is set to [ON]. (Page 45)
• A caution message appears on the screen. To
remove the caution message, touch the screen.
You can also display the picture from the rear view
camera manually without shifting the gear to the
reverse (R) position.
On the pop-up short-cut menu, touch as follows:
32 ENGLISH
Operations while the camera screen is
displayed
To adjust the picture
Touch the area shown below.
Video menu control is shown. For details, see "Video
menu control operations" on page 12.
• To exit video menu control, touch the same area
again.
To display parking guide line
Set <Parking Guidelines> to [ON] (Page 45) or
touch the area shown below.
• To close the parking guidelines, touch the same area
again.
To exit the camera screen
Press HOME on the monitor panel or touch the area
shown below.
Using an external component via ADS
adapter—OEM Features
(Only for DDX396/DDX376BT/DDX276BT)
By connecting this unit to the bus system of the
vehicle using iDataLink (commercially available), this
unit can access the satellite radio source provided for
the vehicle and vehicle information can be displayed
on this unit.
• Displayable screens, button names, and screen
names vary depending on the type of the connected
iDataLink and the model of the vehicle.
• For details, visit <www.idatalink.com/>.
Connecting an ADS adapter
See page 57 for more information.
Using an external component via an ADS
adapter
• For settings to use an ADS adapter, see page 46.
1
Select "OEM Features" as the source.
On the Home screen, touch as follows:
2
Turn on the connected component and
start playing the source.