Table of Contents
Advertisement
CHAPTER 4 GUIDE TO OPERATION
4.1 INSTALLATIONS
• Starting the drive.
Turn on the power supply.
Press the eject button. The tray is ejected from the drive.
Place the disc in the tray with the disc's label facing up.
Press the eject button or press the tray lightly as in the following figure.
The tray is retracted automatically.
Loading start.
CAUTION:
• Do not insert any foreign objects into the disc tray. This could result in a
malfunction.
• Do not manually force the tray to open.
• When the drive is not in use, keep the tray closed to protect against dust and
dirt.
• Do not press down hard on the tray when loading a disc, since this may result
in damage to or malfunction of the tray.
• In case of emergency, eject the tray manually
If for some reason the tray will not eject automatically, press
the eject-bar (for example, insert a straightened
paper clip minimum straight length = 45mm, Diameter = 1~
1.5mm) into the emergency eject hole to manually eject the
tray. (Before proceeding with this emergency step, make sure
that the power is switched OFF.)
8
Min. 45 mm
Paper clip
Advertisement
Table of Contents
