Advertisement
3
Setting Up the Motion-control
Levers
No Parts Required
Procedure
1. Locate the motion-control levers attached, but folded
down on the machine.
2. Remove the upper bolt (3/8 x 1 inch) and washer;
loosen the lower bolt (3/8 x 1 inch).
3. Raise the motion control levers to the upright position.
4. Align the holes in the motion-control lever with the
holes in the control-arm shaft, and install the bolt
and washer removed previously. Repeat this for both
controls levers.
Note: Hand tighten all fasteners.
5. Move the motion-control levers to the park position,
raise the seat, and move the control levers back to the
center position (neutral).
6. Verify that the motion-control levers are properly
aligned.
Note: Adjust as necessary. Tighten all fasteners.
4
Connecting the Seat Hold Bar
No Parts Required
Procedure
1. Locate the seat-hold bar on the frame of the machine.
2. Remove the fasteners.
3. Install the seat hold bar to the seat frame.
4. Secure the bar with the washer and cotter pin removed
previously (Figure 4).
1
5
G014932
1. Cotter pin
2. Washer
3. Seat
3
2
3
4
Figure 4
4. Seat hold bar
5. Hole for pin, seat hold bar
Advertisement
