Toro TimeCutter Series Setup Instructions page 2

1
Connecting the Battery
No Parts Required
Procedure
1. Locate the battery and negative battery cable.
2. Remove the plastic cap from the negative battery post.
3. Remove the fasteners on the negative battery cable,
and use them to secure the negative battery cable to
the negative battery post (Figure 1).
4
3
2
1
6
5
1. Negative battery cable
2. Wing nut
3. Washer
G018395
Figure 1
4. Negative battery post cap
5. Carriage bolt
6. Negative battery post
2
Installing the Rear Hitch
Parts needed for this procedure:
1 Rear hitch
2 Bolt (5/16 x 1 inch)
2 Locknut (5/16 inch)
Procedure
Install the bracket to the frame as shown in Figure 2 and
Figure 3.
g015397
Before assembly
1. Bolts
2
2
Figure 2
2. Locknuts
Figure 3
After assembly
1