Mira Azora Installation And User Manual page 20

Using your Shower
Read the section "User Safety Information" first.
1.
Switch on electrical supply.
3.
Set to desired position.
5.
Allow 10 - 15 seconds for any temperature adjustments to reach the handset.
6.
P r e s s S TO P b u t t o n .
Shower will continue to run
for a few seconds before
stopping.
Note: At the end of every shower make sure that the shower head points
into the catchment area. A small amount of water may be retained in the
shower handset after the shower has been turned off. This may drain over
a few minutes.
1062243-W2-N
2.
Press the 'Start/Stop' button.
4.
Check water temperature before
entering shower.
7.
Isolate power.
20
+
_
+
_
8.
Residual water may drain
over a few minutes.