Advertisement
INSTALLATION (IN-DASH MOUNTING)
The following illustration shows a typical installation. If you have any questions or require information
regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
• If you are not sure how to install this unit correctly, have it installed by a qualified technician.
*
3
When you stand the unit, be careful not to damage the fuse on the rear.
*
3
When using the optional stay /
Fire wall
Dashboard
Install the unit at an angle of less than 30˚.
Removing the unit
Before removing the unit, release the rear section.
When installing the unit without using the sleeve /
In a Toyota car for example, first remove the car radio and install the unit in its place.
(TOYOTA)
Stay (option)
Flat type screws (M5 × 8 mm)
Screw (option)
Note
30˚
Do the required electrical connections.
*
4
*
(M5 × 8 mm)
4
*
4
Bracket
*
4
Pocket
:
When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer screws are
used, they could damage the unit.
8 mm
Insert the two handles, then pull them as
illustrated so that the unit can be removed.
3
Bend the appropriate tabs to hold the
sleeve firmly in place.
*
4
Not supplied for this unit.
*
4
Flat type screws (M5 × 8 mm)
(M5 × 8 mm)
*
4
Bracket
*
4
JVC
*
4
*
4
Advertisement
