Table of Contents
Advertisement
Instruction Manual
JLCHC901
90cm Cooker hood
A
Care and cleaning
Note: Switch off and unplug the cooker hood before carrying out any
cleaning or maintenance work.
Clean the interior and exterior casing using a cloth with water and mild
(neutral) detergent.
Do not use abrasive cleaning materials or scouring pads when cleaning the
cooker hood as this may damage the stainless steel finish.
Cleaning and replacing aluminium filters
This cooker hood is supplied with aluminium filters.
Aluminium filters are designed to absorb grease and dust during cooking.
They should be removed and cleaned once every two months, or more
often if you regularly fry food.
If all the indicators (see page 6) light up when the cooker hood is switched
off, this indicates that the aluminium filters require cleaning. Once the filters
have been cleaned, with the cooker hood switched off hold down the 10
Minute Timer button until the indicator lights go out.
To clean the aluminium filter:
1. Remove the aluminium filter by turning the handle and pulling the filter
downwards.
2. Wash the filter in warm soapy water or in a dishwasher.
3. Replace the aluminium filter in the cooker hood by pushing the filter
into the cooker hood and turning the handle until it locks in position.
The filters may discolour after a few washes. This is normal and does not
mean that they have to be replaced.
Cleaning and replacing charcoal filters
Note: This cooker hood is not supplied with charcoal filters. Charcoal filters
(model number JLCHF08) can be obtained from www.johnlewis.com.
Charcoal filters are designed to absorb grease, dust and unwanted odours
during cooking. They are only required when the cooker hood is used for
recirculating (i.e. when it is not ducted out).
If all the indicators (see page 6) light up when the cooker hood is switched
off, this indicates that the charcoal filters require cleaning. Once the filters
have been replaced, with the cooker hood switched off hold down the 10
Minute Timer button until the indicator lights go out.
Non-regenerable charcoal filters must be replaced at least every six months.
To replace the charcoal filters:
1. Remove the aluminium filter by turning the handle and pulling the filter
downwards.
2. Pull the tab to release the charcoal filter (A) and remove it.
3. Insert the new charcoal filter and push it firmly into position.
4. Replace the aluminium filter in the cooker hood by pushing the filter
into the cooker hood and turning the handle until it locks in position.
7
Advertisement
Table of Contents
