Connecting Network Cable; Ac Power - D-Link DES-1316 Manual

Web-smart 8-port 10/100mbps ethernet switch with 8 10/100mbps 802.3af power over ethernet ports

Hide thumbs Also See for DES-1316:

Table of Contents

Connecting Network Cable

The Switch supports 16 10/100M Ethernet ports and Port 1 ~ 8 are

PoE Enable ports. These PoE ports will be automatically activated

when a compatible terminal is identified. The Switch will supply

power through the Ethernet port to the connected PoE device.

For Legacy devices that are not yet compatible, the PoE port will not

offer the power to these devices. This feature allows users to freely

and safely mix legacy and Power over LAN compatible devices on

their network.

The Switch supports 10Mbps Ethernet or 100Mbps Fast Ethernet and

it runs both in half- and full- duplex mode using two pairs of Category

5 cables.

These RJ45 ports are Auto-MDI type port. The Switch can auto

transform to MDI-II or MDI-X type, so you can just make an easy

connection that without worrying if you are using a standard or

crossover RJ45 cable.

The Switch uses the AC power supply 100-240V AC, 50-60 Hz. The

power switch is located at the rear of the unit adjacent to the AC

power connector and the system fan. The Switch's power supply will

adjust to the local power source automatically and may be turned on

without having any or all LAN segment cables connected.

Table of Contents