Connecting Network Cable - D-Link des-1316 Quick Installation Manual

Connecting Network Cable

DES-1316 support 16 10/100M Ethernet ports and Port 1 ~ port 8 are PoE Enable ports,
these PoE port will automatically activated when a compatible terminal is identified, the
Switch will supply power through the Ethernet port to the connected PoE device.
For the Legacy devices that are not yet compatible, the PoE port will not offer the power
to this device. This feature allows users to freely and safely mix legacy and Power over
LAN compatible devices on their network.
The Switch supports 10Mbps Ethernet or 100Mbps Fast Ethernet and it runs both in half
and full duplex mode using two pair of Category 5 cable.
These RJ45 ports are Auto-MDI type port. The Switch can auto transform to MDI-II or
MDI-X type, so you can just make an easy connection that without worrying if you are
using a standard or crossover RJ45 cable.
AC Power
The Switch used the AC power supply 100-240V AC, 50-60 Hz. The power switch is located at the
rear of the unit adjacent to the AC power connector and the system fan. The switch's power
supply will adjust to the local power source automatically and may be turned on without having
any or all LAN segment cables connected.
3