Hardware Installation - D-Link DCS-2120 Quick Install Manual

Hardware Installation

Hardware Installation
Connect an Ethernet cable to the
Ethernet connector located on the
Internet Camera's bottom panel and
attach it to the network.
Note: It is required that an Ethernet
cable is used during initial setup. Once
your wireless configuration is set, you
may disconnect the Ethernet cable and
begin communicating wirelessly with
your DCS-2120.
Attach the external power supply to the
DC power input connector located on the
Internet Camera's bottom panel (labeled
DC 5V 2A) and connect it to an AC power
outlet.
The LED will flash red and blue when you first power on the unit.
The LED will not turn blue until the camera has received a network
IP address.
 D-Link DCS-10 Quick Install Guide