D-Link DSL-504T User Manual page 63

DSL-504T User's Manual
Advanced - Filters (continued)
The parameters described below are used to set up filter rules
Parameter
Source IP
on
Inbound
you are
a Mask Range, a
pull-down menu. Choosing
WAN or all LAN IP addresses
of rule (Inbound or Outbound) is being
Destination IP
you
opt to
IP from
Source Port
Filter
menu
(ports
Destination Port
or
Inbound
the pull-down
Range or Safe Range
Protocol
for
Action
to
routed
Click the Apply button to put the new rule into effect. Any filter rule configured in the
menu will appear in the Filters List with the new settings. The Router must save the
new settings and reboot before the new rules are applied.
D-Link Systems, Inc.
Description
For an Outbound Filter, this is the IP address or IP addresses
your LAN for which you are creating the filter rule. For an
Filter, this is the IP address or IP addresses for which
Where the Destination IP address resides also depends on if
are configuring an Inbound or Outbound filter rule.You can
indicate a Mask Range, a Single IP, an IP Range or Any
the pull-down menu.
The Source Port is the TCP/UDP port on either the LAN or WAN
depending on if you are configuring an Outbound or Inbound
rule. Select one of the following options from the pull-down
to define a Any Port, Single Port, Port Range or Safe Range
above 1024).
The Destination Port is the TCP/UDP port on either the LAN
WAN depending on if you are configuring an Outbound or
Filter rule. Select one of the following options from
Select the transport protocol (TCP, UDP or All) that will be used
the filter rule.
Select to Allow or Deny transport of the data packets according
the criteria defined in the rule. Packets that are allowed are
to their destination; packets that are denied are
creating the filter rule.You can opt to indicate
Single IP, an IP Range or Any IP from the
Any IP will apply the rule to all
menu to define a Any Port, Single Port, Port
(ports above 1024).
Advanced - Filters
depending on which type
configured.
63