D-Link DSL-504T User Manual page 50

DSL-504T User's Manual
Static IP Address for WAN (continued)
Virtual Circuit:
WAN Settings:
Connection Type: Select the Connection Type from the pull-down menu under the
IP Address: Change the IP address as instructed by your ISP. Your ISP should
Subnet Mask:
Gateway Address:
Primary DNS
Address:
Secondary DNS
Address:
D-Link Systems, Inc.
Set the Virtual Circuit setting to Enabled in the pull-down menu if
it is not already enabled.
Static IP Address is selected.
Static IP heading. Your ISP should provide this information to you.
The available options are IPOA, 1483 Bridged VC-Mux, 1483 Bridged
LLC,1483 Routed LLC, and 1483 Routed VC-Mux. If you have not
been provided specific information for the Connection Type setting,
leave the default setting.
have provided these IP settings to you.
Change the subnet mask as instructed by your ISP.Your ISP should
have provided these IP settings to you.
Change the gateway address as instructed by your ISP. Your ISP
should have provided these IP settings to you.
Change the primary DNS address as instructed by your ISP. Your
ISP should have provided this setting to you.
Change the secondary DNS address (if available) as instructed
by your ISP. Your ISP should have provided this setting to you (if
available).
NAT: Set NAT to Enabled unless you have been told that NAT must be
Disabled for your account.
ATM: If you have not been instructed to change the ATM settings at the
bottom of the menu, leave these at the default settings. If you have
been given new settings to configure, select the Service Category
and type in the values for PCR and VCI in Kbps.
Apply: Click Apply when you have completed the configuration.
The new settings must be saved and the Router must be restarted for the settings to go into
effect. To Save & Reboot the Router, click on the Tools directory tab and then click the Misc
menu button. In the Misc Settings menu, click the Reboot button under Force the DSL-504T
to system restart. The Router will save the new settings and restart. Upon restarting the
Router will automatically establish the WAN connection
Configuring the WAN Connection
50