D-Link DSL-504T User Manual page 54

DSL-504T User's Manual
Bridged Connection for WAN (continued)
ATM VC Setting
ATM VC Setting
VPI & VCI:
ATM VC Setting
Virtual Circuit:
WAN Setting: Click to select the Bridge Mode radio button in the WAN Settings
Bridge Mode
Connection Type:
The new settings must be saved and the Router must be restarted for the settings to go into
effect. To Save & Reboot the Router, click on the Tools directory tab and then click the Misc
menu button. In the Misc Settings menu, click the Reboot button under Force the DSL-504T
to system restart. The Router will save the new settings and restart. Upon restarting the
Router will automatically establish the WAN connection
D-Link Systems, Inc.
Under the ATM VC Setting heading, do not change the PVC (Pvc0)
PVC:
index for the initial connection.
Also under the ATM VC Setting, you see two numbers, the VCI and
VPI values. Do not change the VPI or VCI value unless you have
been told to do so. These numbers are used to define a unique path
for your connection. If you have been given specific settings for this
to configure, type in the correct values assigned by your ISP.
Set the Virtual Circuit setting to Enabled in the pull-down menu if
it is not already enabled
options list. The menu will change to offer a different set of
configuration options.
Under Bridge Mode, choose the Connection Type from the
pull-down menu. For bridge mode connections the available
encapsulation methods are 1483 Bridged IP LLC and 1483 Bridged
IP VCMux.
If you have not been instructed to change the ATM settings at the
ATM:
bottom of the menu, leave these at the default settings. If you have
been given new settings to configure, select the Service Category
and type in the values for PCR and VCI in Kbps.
Apply: Click Apply when you have completed the configuration.
Configuring the WAN Connection
54