Table of Contents
Advertisement
20
www.electrolux.com
of the cleaning with the function: End
Time.
The signal sounds at the end of cleaning.
The oven turns off.
3. Press any sensor field to stop the
signal.
4. When the oven cools down, clean the
cavity with a wet soft cloth.
Spots or discolouration of the catalytic
coating have no effect on Catalytic
cleaning.
11.4 Removing and installing the
door
You can remove the door to clean it.
WARNING!
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
3. Close the door until it is at an angle of
approximately 45°.
4. Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
6. Clean the glass panel with water and
soap. Dry the glass panel carefully.
A
A
45°
When the cleaning is completed, install the
door. Do the above steps in the opposite
sequence.
11.5 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
cavity.
The top lamp
1. Turn the lamp glass cover to remove
it.
2. Clean the glass cover.
3. Replace the lamp with a halogen, 230
V, 40 W, 300 °C heat resistant lamp.
4. Install the glass cover.
The side lamp
1. Remove the left shelf support to get
access to the lamp.
2. Use a narrow, blunt object (e.g. a
teaspoon) to remove the glass cover.
Advertisement
Table of Contents
