Camera Configuration - D-Link DCS-1000 Supplementary Manual

Camera Configuration

Follow the instructions for setting up the camera either wired/wireless. If this is a home and the
camera is behind an Internet router additional set-up notes for you router can be found on
www.dlink.com.
Once logged into the camera on the main menu click/select trigger and the following screen will
appear.
These fields control Input Trigger 1 and Trigger 2. Each Input trigger can trigger either or both
Output triggers.
SMTP Server Address:
Name or IP address of a Mail Server that camera can use to send.
Sender E-Mail:
Name of the Camera who sent the mail
Receiver E-Mail:
Name of person to receive pictures when sensors are activated
Sending Interval:
The time between additional sequences of pictures are taken when sensors activated
Sending Times:
The number of times the camera takes additional sequences of pictures based on Sending Interval.
Trigger I/O:
Enable Output trigger for the specified input trigger
Output # Time:
How long the output trigger is activated if Sensor is activated. (ie. How long should siren ring?)
INPUT TRIGGER RESPONSE NOTES!!!
The camera will take a sequence of pictures and the output trigger is activated when there is a
change open or close of the sensor. Example: The magnetic switch is opened, a sequence is
sent and siren goes off. The switch is then closed, an additional sequence is sent and the alarm
goes off. The camera is designed this way so if there is an intrusion, the intrusion is detect if
intruder simply opens then closes the entrance.