D-Link DCS-1000 Supplementary Manual page 2

Using the dcs-1000/dcs-1000w ip camera as a security system

Hide thumbs Also See for DCS-1000:

Basic Hardware Set-up Diagram

The diagram below shows the hardware configuration for 1 Active Sensor (PIR Motion Sensor), 1

Passive Sensor (Magnetic Switch), and 1 output (For Relay) for a siren.

Passive Component Notes!!!

Only simple magnetic or contact switches can be used for Passive components. This limitation is

by the camera only supplying 5V and less then 100mA current to those circuits. Distance for

passive components is limited by a viewable camera range of about 25 Ft using 26GA wire.

Active Component Notes!!!

A separate power supply is needed for these devices. In order to choose the proper PS. The total

current draw by all the components cannot exceed the Max supplied by the power supply.

Example

Our PIR Motion Detector = 17 mA = .017A

Our Relay = 60 mA = .06A

Siren = 200mA = .20A

Total : .277A

Purchased DC power adapter 12V DC 1.2A Max to cover all Active Sensors and Siren, with room

to grow.

Dcs-1000w