Auxiliary Fence - Delta 26-2240 Instruction Manual

Bevel Angle Setting
33.85°
33.85°
33.85°
33.85°

AUXILIARY FENCE

For cutting certain workpieces, you may require a larger fence
surface area to accommodate the workpiece. The auxiliary
fence should be made using 3/4" thick wood. Use the holes
which are pre-drilled in the fence to attach an auxiliary fence.
Never use auxiliary fence which interferes or
makes contact with saw head. Always check for clearance
between auxiliary fence and saw head before making cuts.
To make slide cuts using an auxiliary fence, a
notch must be cut out in the auxiliary fence prior to attaching
to saw fence.
The auxiliary fence can only be used with the
0 degree bevel angle. Remove the auxiliary fence before
making a bevel cut.
1.
1. See figure 25 for auxiliary fence dimensions.
2.
2. Place auxiliary fence wood against miter saw fence. See figure 24. The maximum height for this wood must not exceed
5.5". Check to make sure auxiliary fence does make contact with saw head, check with saw head in the full DOWN and fully
RETRACTED position.
3.
3. Mark the hole locations on the backside of the auxiliary fence board.
4.
4. Drill the marked hole locations all the way through the auxiliary fence. Countersink the drilled holes on the front side of
your auxiliary fence board.
5.
5. Fasten the auxiliary fence using flat head screws. Secure from behind using flat washers and nuts.
6.
6. Make a full depth cut through the auxiliary fence, to create the blade slot.
7.
7. The notch shown in figure 25 must be cut out in order to make slide cuts using the auxiliary fence.
OPERATION
Type of Cut
Left side, inside corner
Right side, inside corner
Left side, outside corner
Right side, outside corner
Figure 25
Steps
1. Top edge of molding against fence
2. Miter table set right 31.62°
3. Save left end of cut
1. Bottom edge of molding against fence
2. Miter table set left 31.62°
3. Save left end of cut
1. Bottom edge of molding against fence
2. Miter table set left 31.62°
3. Save right end of cut
1. Top edge of molding against fence
2. Miter table set right 31.62°
3. Save right end of cut
18
Figure 24