Table of Contents
Advertisement
Fault Codes
In the event of a problem with the appliance, the display may show
one of the following fault codes:
Error Code
Water leakage has been detected
26
Error description
The waste water cannot be
discharged
Continual fill error
Faulty flow meter
Inadequate water supply
Faulty NTC
Water temperature too high
Heater error: Inadequate heat
Diverter position problem
Alarm is active against water
overflow
Electronic card parameter faulty
Electronic card water hardness
faulty
Faulty turbidity sensor
•
Turn off the dishwasher and disconnect the water supply
•
Contact CDA Customer Care
•
Drain hose is blocked
•
The filters of your machine might be blocked
•
Restart the dishwasher and cancel the programme
•
If the error continues, contact CDA Customer Care
•
Contact CDA Customer Care
•
Contact CDA Customer Care
•
Make sure the water tap is fully open
•
Close the water tap, separate the water inlet hose from
the tap
and clean the filter.
•
Restart the dishwasher.
•
If the error continues, contact CDA Customer Care
•
Contact CDA Customer Care
•
Contact CDA Customer Care
•
Contact CDA Customer Care
•
Contact CDA Customer Care
•
Contact CDA Customer Care
•
Contact CDA Customer Care
•
Check the water hardness is set for your water supply
•
If the error continues, contact CDA Customer Care
•
Contact CDA Customer Care
Advice
Advertisement
Table of Contents
