Table of Contents
Advertisement
Please note: The dishwasher stores the most recently used
programme in its memory. To change the programme, simply
press the Programme Selection button.
At the end of a programme
If possible, do not open the dishwasher door once the programme
has started.
At the end of a programme, the dishwasher will beep five times, and
the end of programme indicator light will switch on.
Changing a programme
It is possible to change the programme if necessary once the
programme has started.
•
First open the door slightly to reduce the risk of water spillage.
•
Press the programme selection button until the required
programme is shown on the display.
•
Then close the door. The dishwasher will begin the new
programme from the point at which the old programme stopped.
Cancelling a programme
It is possible to cancel the programme once it has started.
•
First open the door slightly to reduce the risk of water spillage.
•
Press and hold in the programme selection button (3) for three
seconds until the end of programme indicator flashes and a "1"
shows on the display.
•
Then close the door. The dishwasher will run a drain cycle which
will take approximately 30 seconds. Once this is complete, the
dishwasher will beep five times and the end of programme light
will switch on.
10
Advertisement
Table of Contents
