Table of Contents
Advertisement
8-2. Selecting a suitable
location
8-3. Connecting the PC
•
15 pin D-sub / DVI-D /
HDMI
S243X / S243A
Multi Function 2D/3D Wide Monitor
•
Place the monitor at least 30cm from other electrical or heat-emitting equipment
and allow at least 10cm on each side for ventilation.
•
Place the monitor in a position where no light shines directly onto or is reflected
on the screen.
•
To reduce eye strain, avoid installing the display unit against a bright
background such as a window.
•
Position the monitor so that the top of the screen is no higher than eye level.
•
Position the monitor directly in front of you at a comfortable reading distance.
(around 45 to 90cm)
!
Before you start cabling your monitor, check that the power
is off on all units. To avoid any possibility of electric shock,
always connect your equipment to properly earthed outlets.
1. Insert the other 15-pin/DVI-D/HDMI signal cable connector into the
15-pin VGA/DVI-D/ HDMI connection on your computer and screw it down.
* When using DVI to HDMI cable connection, you must use audio connection and set "DVI to HDMI
AUDIO" menu to On.
2. Plug the power cord connection to connection on the monitor.
3. Plug the other end of the power cord to your computer's main supply or to a
100V-240V earthed electrical outlet.
4. Turn on the monitor using the power switch and check that the power LED is
on. If not, repeat steps 1,2,3 and 4 or refer to the Troubleshooting section of
this guide.
10/31
Advertisement
Table of Contents
