Table of Contents
Advertisement
5. 3D Monitor Setting Guide
6. Q&A for 3D Mode
S243X / S243A
Multi Function 2D/3D Wide Monitor
•
Optimal resolution for 3D viewing is 1920*1200/60Hz. If you run it on different
resolutions, its 3D effects can decrease.
•
Use signal input source at RGB under PC mode or DVI mode. DVI mode is
recommended.
•
For 3D viewing, go to 1:1 mode under Display Control of OSD MENU before viewing
it (Monitor Manual: see 25 page). Viewing on a different mode may decrease 3D
effects.
•
On 1:1 mode, the screen size changes according to the input resolution. It doesn't
mean that it has some problems with it. It just operates 1:1 mode without scaling
the input signal.
•
Install the 3D Software. For details, see the Installation Guide.
•
There is something like oil stain on the monitor screen.
- It is due to interferences of light waves within the air layers between the surface
of LCD and the 3D filter. It is not defective.
•
3D stereoscopic images are seen as two separate images.
1. When you don't wear 3D glasses enclosed Please use the 3D glasses.
2. When you view it away from visual angle.
- To view 3D stereoscopic imaging optimally, you'd better keep the distance of 60 cm.
- 1m from the monitor screen.
- If you exceed 75° out of the left/right visual angle or 10° out of the top/bottom
visual angle while viewing 3D images, you cannot enjoy 3D images properly. So
keep the visual angle as provided above.
6/31
Advertisement
Table of Contents
