Light Kit Installation - Honeywell PALM ISLAND Manual

22. (Optional) To install the fan without a light kit:
Remove the three screws and washers from the
optional cap. Align holes in optional cap with holes
in switch housing. Re-insert screws and washers
that were previously removed. Use a Phillips
screwdriver (not included) to secure all screws
(Fig. 22).
Note: The optional cap should be oriented so its notch
is aligned with the reverse switch.
Proceed to step 27.
Screw
Washer
23. Remove three screws and washers from the light
kit. Connect the white wire from the switch housing
to the white wire from the light kit. Connect the
black wire from the upper switch housing to the
black wire from the light kit. Make sure plugs
connect tightly (Fig. 23).
Washer
Screw
24. Align holes in the light kit with holes in upper switch
housing. Re-insert screws and washers that were
previously removed. Use a Phillips screwdriver (not
included) to secure all screws (Fig. 24).
Note: The light kit should be oriented so its notch is
aligned with the reverse switch.
Washer
Screw

LIGHT KIT INSTALLATION

14
Fig. 22
Reverse
Switch
Notch
Optional
Cap
Fig. 23
Light Kit
Fig. 24
Reverse
Switch
Screw
and
Washer
Screw and
washer
Screw and
Washer