Denon AVR-S730H Owner's Manual page 206

Contents Connections
DTS sound is not output.
Check that the digital audio output setting on the connected device is set to "DTS".
0
Dolby Atmos, Dolby TrueHD, DTS-HD, Dolby Digital Plus audio is not output.
Make HDMI connections. (v p. 52)
0
Check the digital audio output setting on the connected device. On some devices, "PCM" is set by default.
0
DTS Neural:X mode cannot be selected.
DTS Neural:X cannot be selected when using the headphones.
0
Dolby Surround mode cannot be selected.
Dolby Surround cannot be selected when using the headphones.
0
Audyssey MultEQ ® , Audyssey Dynamic EQ
These cannot be selected when you have not performed Audyssey
0
Switch to a sound mode other than "Direct". (v p. 108)
0
These cannot be selected when using the headphones.
0
"Restorer" cannot be selected.
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS
0
surround, "Restorer" cannot be used. (v p. 138)
Switch to a sound mode other than "Direct". (v p. 108)
0
No sound is output when using ZONE2.
Digital signal audio input from the HDMI connector or digital audio connectors (OPTICAL/COAXIAL) cannot be played back. Use analog connections.
0
When listening to audio from a Bluetooth device in ZONE2, remove any obstructions between the Bluetooth device and this unit and use it within a
0
range of about 98.4 ft/30 m.
Front panel Display
Playback
® and Audyssey Dynamic Volume
® Setup. (v p. 159)
206
Rear panel
Settings Tips
® cannot be selected.
Remote Index
Appendix