Denon AVR-S730H Owner's Manual page 163

Contents Connections
5
Select "Start", then press ENTER.
Audyssey ® Setup can also make the following settings.
Amp Assign
0
The signals output from the SURROUND BACK speaker
terminals can be switched in accordance with your speaker
environment. ("Amp Assign" (v p. 170))
Channel Select
0
If channels that are not to be used are set in advance,
measurement for the set channels is skipped, and measuring
time can be reduced. You can also change the number of
surround back speakers.
Dolby Sp.Setup
0
Set the distance between the Dolby Atmos Enabled speaker and
the ceiling.
This can be set when "Assign Mode" is set to "Front Dolby" or
"Surround Dolby" in the "Amp Assign" settings. (v p. 170)
Front panel Display
Playback Settings
6
Follow the instructions on the screen display and press
"Next" to proceed further.
7
When the following screen is displayed, select "Begin
Test" and then press ENTER.
Start the measurement of the first position.
0 If "Caution!" is displayed on TV screen:
163
Rear panel
Tips
Audyssey Setup
Select "Begin Test" to Start the Calibration.
NOTE:You will hear a series of loud test tones
starting and stopping during the tests.
Ear Height
Back
Measurement requires several minutes.
0
NOTE
0 Go to "Error messages" (v p. 168). Check any related items, and
perform the necessary procedures.
Remote Index
Appendix
Begin Test