Controls - GE APEL70 Owner's Manual

Hide thumbs Also See for APEL70:
Table of Contents

Advertisement

Available languages

Available languages

Controls

Power On
Clean the Filter
indicator light
indicator light
Controls
NOTE: When the bucket is full or removed, the controls
cannot be set.
1. Power Pad
Press to turn the dehumidifier on and off.
2. Filter Timer
indicator light will glow to remind you to clean the filter.
Remove the filter and clean it.
and Cleaning section.
3. Humidity Set Control Pads
NOTE:
settings if attached to a hose to drain or until the bucket
is full.
Other Features
Empty Light
Glows when the bucket is ready to be emptied, or when the
bucket is removed or not replaced in the proper position.
Alarm
If the bucket is full or missing for more than 3 minutes, an
empty and replace the bucket.
Auto Shut Off
when the bucket is full, or when the bucket is removed
Continuous
Operation on
indicator light
Humidity %
Nonstop
On
Filter
-
Filter
Power
Timer
Hold 3 Sec To Rest
High, Medium and
4 hour or 2 hour
Low fan indicator
delay off
light
indicator lights
Low
Medium
4 hour
High
2 hour
+
Delay
Fan
Off
When you first use the dehumidifier, set the humidity
dehumidifier to achieve the humidity level. If you still
have damper air than desired, set the humidity level
dehumidification.
4. Display
5. Fan Speed Pad
Controls the fan speed.
Press to select either High, Medium or Low fan
speed.
removal. When the humidity has been reduced and
quiet operation is preferred, set the fan control to
Medium or Low.
6. Delay Off
While the dehumidifier is in operation, press this pad to
7. Pump
Activates the internal pump function. Press for 3 seconds
to activate the internal pump for automatic removal of
illuminated after 3 seconds. Press to deactivate the
pump.
or not replaced in the proper position. NOTE:
removed.
Auto Defrost
When frost builds up on the evaporator coils, the
compressor will cycle off and the fan will continue to run
until the frost disappears.
Power Outage
In the case of a power outage or interruption, the unit will
automatically restart, in the settings last used, after the
power is restored.
Bucket Full light indicates
bucket needs to be emptied
or is not in place in the unit
Empty
Pump
Pump
Pump light
Hold 3 Sec
Requires Hose
indicates the
pump is activated
49-7766

Advertisement

Chapters

Table of Contents
loading

Table of Contents